Wood decoration panel installation precautions:

1. After the decorative panel arrives at the construction site, it should be stored in a ventilated and dry room, and pay attention to moisture resistance. Before use, it is necessary to clean the dust and impurities on the surface of the decorative panel with fine sandpaper (or with an air pressure tube). The surface of the factory panel is sanded well, just use soft feathers to clean the dust and impurities on the surface, and can not be heavy sand.

2. Decorate the surface of the panel with nitrocellulose varnish brush, let it dry for 30-60 minutes after brushing, sand the panel after the paint dries, and then brush the second layer of primer, and then polish it, and so on. Primer should be applied at least three times before finishing.

3. After completing the decoration panel construction, apply peptide paint twice, and then fill the nail holes with ash, so that the nail holes cannot be seen within 1 meter distance as the standard. Now, some decoration companies use the method of applying strong glue to the bottom of the panel instead of pinning, this method can obtain better decorative effects, and no longer need to nail holes to fill the ash, but its cost is slightly higher.

4, after the completion of the filling work, continue to brush the peptide paint five times, each brush should be sanded to polish the finish, and then color and repair the local prominent nail holes.

5. Polish the finish with clean water 2-3 times until there are no obvious oil brush marks.

6, brush last three nitro paint, used for protection facing and improve the smoothness of the surface.

7, the finished panel, to protect the paper skin. The panel is not suitable for use in direct sunlight and wet, dry (such as opposite the air conditioning outlet, next to the radiator, etc.), otherwise the panel will appear mildew, discoloration, cracking and other problems.